Upgrade your CrossBoard with the right tool
To increase the cultivation capacity of your CrossBoard, we offer a wide and varied selection of tools. Note that the angled CrossBoard point can be reversed to alter the levelling effect on lighter soils.

CAD 113.00/98.90 msrp
CrossBoard Heavy tine, 150mm Art. No: 441344, curved. Art. No: 202181, straight.

CAD 80.50/60.90 msrp
CrossBoard Light tine 45mm Art. No: 421626, curved. Art. No: 201787, straight.

CAD 27.50 msrp
CrossBoard point 45mm, straight High throughflow. Art. No: 419998.

CAD 32.50 msrp
CrossBoard point 45mm, angled Aggressive with high throughflow. Art. No: 419997.

CAD 42.50 msrp
CrossBoard point 100mm, angled Aggressive with good throughflow. Can be turned for less aggressive cultivation and soil displacement. Art. No: 419999.

CAD 55.90
CrossBoard point 150mm, angled Aggressive with moderate throughflow. Mounting of Single- or DoubleKnife possible. Art. No: 440603.

CAD 44.90 msrp
CrossBoard point 100mm, straight Good throughflow. Art. No: 419996.

CAD 52.50 msrp
CrossBoard point 150mm, straight Moderate throughflow. Art. No: 425587.
SingleKnife – tilt cutting blades that increase harrow efficiency
During autumn work in heavier soils, the first rows of harrow tines have to work hard, as they do a lot of cutting work in the tilth. Under difficult conditions, this sometimes causes them to lift more soil than is optimal, which can affect seedbed precision.
By mounting SingleKnife on the CrossBoard, tilth cutting ability is drastically increased. The harrow gets an additional row of tines with only 25 cm spacing c-c. This relieves the first rows of harrow tines and increases their working precision, while also getting more done by reducing the harrow’s total effective tine spacing to just 5.8 cm. A positive side effect of SingleKnife is that they also push up slightly more material to the CrossBoard, which produces finer soil as its grinding ability increases.
SingleKnife is easily mounted without tools, using the QuickChange system. SingleKnife is available in standard and Marathon versions, the latter of which is fitted with tungsten carbide plates. The tungsten carbide ensures both maintained work quality and an extremely long service life, which always pays off in the long run.

CAD 32.50 msrp
SingleKnife Art. No: 430400.

CAD 82.90 msrp
SingleKnife Marathon Art. No: 245060.
Bolt & nut for CrossBoard points
Good to know!
Avoid ridge formation
To avoid the risk of ridge formation after aggressive CrossBoard with curved points, you can mount a straight point to the outer most position on each side.

Good to know!
Mounting made easy
Väderstad’s QuickChange System completely relieves you from tools for mounting knife tools on CrossBoard. The blades are easy to adjust into different positions for desired aggressivity.

